Colt Anaconda/Trooper MKV grips

These walnut grips were used on Colt Anaconda and Trooper Mk IV. Will also fit V-frame Lawman and King Cobra. Finished in natural clear coat to replicate the original factory finish.

These grips will NOT fit the current production Anaconda, and at this point we are not offering “retro style” grips for it. However, any of our Python grips will fit the current production Anaconda.

IMPORTANT: These particular grips are meant for display and restoration purposes only. The original grips were very poorly designed, just a thin shell of wood that can easily crack from the recoil when you shoot the gun. Since our grips are exact reproductions of Colt’s design, they can crack in the very same manner. This is why original grips are so difficult to find, and this is also why we can’t guarantee that our reproductions will hold up when shooting.

The frame width and pin sizes on the Anacondas and King Cobras can vary slightly, so we make the grips to fit the largest frame we have had access to. This means that the grips will always fit, but they may be a bit loose on some guns. The fitting procedure we recommend is:

To tighten loose pin fit, place small pieces of paper towel on the pin holes and put the panel on the frame. This is usually all it takes to make up for the difference in pin size, but more paper can be added if you prefer a tighter fit.

To adjust side-to-side fit, place a piece of sandpaper on a flat surface. Sand the mating surfaces on the panels a little bit at a time until they fit snugly. Test fit frequently to ensure that you don’t sand off too much.

BEFORE ORDERING, please make yourself familiar with the nature of original style grips! Click here for more information